Powersteering bracket

[harbormaster]

I am using a different powersteering bracket for my 502 in the boat.
Two of the bolt holes appear to be counter sunk for pwr steering pump clearance. Anyone seen a bracket like this before?
I went to a ships store to get counter sunk screws but they did not have any large enough.
Anyone have any laying around??

[gcarter]

Try a fastener supply house.

[harbormaster]

Thanks for the speedy answer George. We actually have one of those here BUT I was looking for the actual oem fastener that goes there.

[BUIZILLA]

Is that for 3/8" or 7/16" thread ? I believe it's a flat head, allen head design.

JH

[Rootsy]

which holes in the bracket in particular... can you take an isometric photograph of it?
on the mouse motor with a GM pump and serpentine system, the bolts that pass through the bracket into the PS pump are a metric thread and have a very short head for clearance... more so you can get them behind the pulley and into the pump