View Full Version : risers
Blue Bullet
11-14-2005, 06:41 PM
I own a 1967 18' Donzi 2 + 3 w/427 Hollman Moody engine. I'm at the end of rebuilding the engine and need risers. 2-esses and 2-90 degree pcs. Does anyone have a link or know of someone that possesses these parts. Maybe someone works with aluminum and can make new pcs for me. I'll take all offers.
Sincerely,
Rich
A few sets have shown up on Ebay from time to time, its worth poking around there.
Phil
Woodsy
11-15-2005, 07:01 AM
Rich...
Although it will add a ton of $$$ to the project, you should consider a custom set of headers from CMI. 427 Ford marine parts are extremely rare, I would hate to blow a rare 427 engine due to an old piece of cast iron.
Woodsy
CHACHI
11-15-2005, 09:19 AM
Rich...
Although it will add a ton of $$$ to the project, you should consider a custom set of headers from CMI. 427 Ford marine parts are extremely rare, I would hate to blow a rare 427 engine due to an old piece of cast iron.
WoodsyANY Ford 427 FE parts are rare! Ken
Dave is right on old stuff, some fresh water aluminum dies show up. A less costly alternative would be after market cast iron in the link below.
http://www.marineparts.com/partspages/OMC/OMC29.htm
Blue Bullet
11-15-2005, 08:34 PM
Thanks for the insight (web page) I will look into it. The originals are aluminum fantastic piece of craftsmanship. When I get it all finished..pictures galore. thanks again, rich
Powered by vBulletin® Version 4.2.5 Copyright © 2024 vBulletin Solutions Inc. All rights reserved.