Custom Switch Plates

[87Z33]

I have been looking for 3 custom switch plates, one for the dash switches, one for the trim switches and one for the ignition....ideally want all to match when I am done.
I have seen the yellow dash (can't recall the boat/owner) very nice! Richard's carbon fiber - awesome and some custom plates available at dana marine products....powder coated/anodized billet aluminum very nice!

Dana's 8 switch plate is nice but they have nothing to address my trim switches, I am thinking about having a shop machine a set of matching plates and if there is any interest on the part of other Z33/Z29 owners the price gets pretty cheap if I do 4 -10 sets.

I was thinking of a 10 - 12 switch plate above the wheel and a 5 switch plate for the trim panel using Carling Rockers (Contura V) lighted.

Is there any benefit to using toggles? They do take up less room.

[Trueser]

I would be interested, Can you match the ones from DANA?

By the way I have the diagram for you on your trim. Send me a email with your address and I will ship it to you today.


Mike

[smokediver]

Doc had some pretty cool stuff done .... the guy he used makes dashes and i am sure could make anything you want ...

[87Z33]

Thanks Mike --

I really like Dana's stuff, they're reasonably priced but not cheap.
I need about 10-12 switches.
I just don't want to have one switch plate of theirs (8 position-$180)then have to buy a 4 position ($120) and a still not have a trim plate or ignition switch plate that matches.

[thriller]

Try This?

www.trickmarine.com (http://www.trickmarine.com)

MM

[ChromeGorilla]

Try This?

www.trickmarine.com (http://www.trickmarine.com)

MM



Or this even..... www.trickmarine.net ;)