87Z33
08-09-2005, 10:24 AM
I have been looking for 3 custom switch plates, one for the dash switches, one for the trim switches and one for the ignition....ideally want all to match when I am done.
I have seen the yellow dash (can't recall the boat/owner) very nice! Richard's carbon fiber - awesome and some custom plates available at dana marine products....powder coated/anodized billet aluminum very nice!
Dana's 8 switch plate is nice but they have nothing to address my trim switches, I am thinking about having a shop machine a set of matching plates and if there is any interest on the part of other Z33/Z29 owners the price gets pretty cheap if I do 4 -10 sets.
I was thinking of a 10 - 12 switch plate above the wheel and a 5 switch plate for the trim panel using Carling Rockers (Contura V) lighted.
Is there any benefit to using toggles? They do take up less room.
I have seen the yellow dash (can't recall the boat/owner) very nice! Richard's carbon fiber - awesome and some custom plates available at dana marine products....powder coated/anodized billet aluminum very nice!
Dana's 8 switch plate is nice but they have nothing to address my trim switches, I am thinking about having a shop machine a set of matching plates and if there is any interest on the part of other Z33/Z29 owners the price gets pretty cheap if I do 4 -10 sets.
I was thinking of a 10 - 12 switch plate above the wheel and a 5 switch plate for the trim panel using Carling Rockers (Contura V) lighted.
Is there any benefit to using toggles? They do take up less room.