harbormaster
07-27-2005, 09:11 AM
A lot of people have been asking so I will post it here.
I finally have both of my late model transom assemblies that need bolting on.
Stuff needed to finish the 31 Scarab Viper.(all it takes is money!)
1. Wiring up the dash panels - Donzigo has been kind enough to volunteer for this.
2). (2) HD Bravo drive couplers @ about 340.00 each
3). (2) pair of manifolds - I have 1 pair of aluminum 496 manifolds. They bolt up but I need to see if they are compatible.
4). (2) Bravo lower units - I have two that need rebuilding
5). (2) upper alternator brackets. The old ones are rusted out.
6). (2) Mercruiser engine harnesses @ 140.00 each
When I finally have these things I can start putting in the engines.
All it takes is money.....
If anyone needs web development or programing for your company let me know.
I finally have both of my late model transom assemblies that need bolting on.
Stuff needed to finish the 31 Scarab Viper.(all it takes is money!)
1. Wiring up the dash panels - Donzigo has been kind enough to volunteer for this.
2). (2) HD Bravo drive couplers @ about 340.00 each
3). (2) pair of manifolds - I have 1 pair of aluminum 496 manifolds. They bolt up but I need to see if they are compatible.
4). (2) Bravo lower units - I have two that need rebuilding
5). (2) upper alternator brackets. The old ones are rusted out.
6). (2) Mercruiser engine harnesses @ 140.00 each
When I finally have these things I can start putting in the engines.
All it takes is money.....
If anyone needs web development or programing for your company let me know.