Can someone measure their hatch strut locations?

[Lenny]

http://www.donzi.net/forums/attachment.php?attachmentid=11098&stc=1&thumb=1

http://www.donzi.net/forums/attachment.php?attachmentid=11097&stc=1&thumb=1

http://www.donzi.net/forums/attachment.php?attachmentid=11096&stc=1&thumb=1

Can someone measure the location on the hull to the forward location of the strut support and also the location for the blind cover on the hatch? The distance in would be nice too for the blind cover on the hatch.

Thanx, ordered 'em today. Thanx Jamie.

[jstokes8407]

I also ordered mine today and that info would be very helpful :beer: :beer:

[gero1]

on the hood,12.5 from stern edge of hood, 2 7/8 from p and s sides..27 5/8 from stern edge of the well that the hood fits down into to l.e of bracket on hull.. hood measurements where taken on out side of hood. THIS IS FOR A 22!

[gcarter]

http://www.donzi.net/forums/attachment.php?attachmentid=11098&stc=1&thumb=1

http://www.donzi.net/forums/attachment.php?attachmentid=11097&stc=1&thumb=1

http://www.donzi.net/forums/attachment.php?attachmentid=11096&stc=1&thumb=1

Can someone measure the location on the hull to the forward location of the strut support and also the location for the blind cover on the hatch? The distance in would be nice too for the blind cover on the hatch.

Thanx, ordered 'em today. Thanx Jamie.
Lenny, you CAN convert Roberts answer into MM's can't you? :) :jestera: :rolleyes:

[Lenny]

Robert, the 22 and the Classic 18, no matter. It is the rams that need to be located in the same places wherever that may be. Lift will be identical if placed in the same locations. On the hatch, the distance from hatch rear to blind cover, where did you measure that to. (center, beginning as in transom end of cover, or bow end of cover? Side measurements, was that to the beginning of the blind cover, middle or inside from either port or starboard?)

George...

12 1/2" = 318.77 MM
2 7/8" = 73.02 MM
27 5/8" = 701.67 MM :uzi: :dolphin: :D :D :D

[gero1]

hood numbers where taken from back edge of hood, hook your tape on back edge of hood, should be 12 1/2 inches to begigging of blind do daddy thing. for the side, hook tape on edge of hood and go in 2 7/8 to begining of that thing, these where taken with the hood down.... now for the other end i opened the hood and mesured from the back edge of the well that the hood fits in, thers a small canel deal that keeps rain water off your moter, the back edge of that. with your hood closed you should only have about 1/8 or so of a gap from that part of the boat. that mersurement is 27 5/8...........................WOW i ned 2 laren howi 2 spill if you need more call me around 7:30 ct 615-666-7600