View Full Version : Diamond Plate
springs
03-07-2005, 02:44 PM
Does anyone know where I can find anodized or powder coated aluminum diamond plate?
Trueser
03-07-2005, 03:24 PM
Check a local RV/Trailer place , That is where I found it.
It came in a 4x8 sheet
Good luck
Mike
Last Tango
03-07-2005, 03:55 PM
Powerdertech Plus
98 Industrial Loop
Orange Park, Florida 32073
(904)269-1719
Howard Cook
Anything you want, any color you want, any shape you want (althought I doubt if he can do THIS :smileybo: in diamond plate even IF diamonds ARE a girls' best friend).
Tell him Mark Laszlo referred you. He does a lot of marine powdercoating and diamond plate for the Jacksonville Performance Boat Club.
springs
03-07-2005, 06:00 PM
Thanks guys.
Why not fiberglass diamond plate? Is it for your boat?
It is MUCH easier to cut, MUCH lighter, and flexible.
It never corrodes either.
springs
03-07-2005, 07:07 PM
Where would I find fiberglass diamond plate?
I can make it for you.
I can make it in red or white.
10' X 4' sheet $300.00 plus shipping.
http://www.donzi.net/forums/attachment.php?attachmentid=9815
http://www.donzi.net/forums/attachment.php?attachmentid=9816
Jerry Eisele
03-07-2005, 07:49 PM
Nice looking engine compartment Cig!!!!
Speed-Racer
03-07-2005, 08:54 PM
Ted....man that was an awesome 22'....I get goose bumps thinkin about it :hyper:
http://instagiber.net/smiliesdotcom/otn/sad/wzbigcry.gifhttp://instagiber.net/smiliesdotcom/otn/sad/mecry.gifhttp://instagiber.net/smiliesdotcom/contrib/aahmed/azcrying.gif
springs
03-07-2005, 09:58 PM
What's the chance's of getting it in teal?
Dr. Dan
03-07-2005, 10:17 PM
:spongebob Yeah....What about Teal?
Doc :beer:
You guys can get any color you want......as long as its red or white.
Problem is that the color stays in the mold a little........then the next piece out has little specs of the previous color all in it.
I only have 2 molds right now.
springs
03-07-2005, 10:29 PM
You guys can get any color you want......as long as its red or white.
Problem is that the color stays in the mold a little........then the next piece out has little specs of the previous color all in it.
I only have 2 molds right now.
I don't think red would go that well and the white, well I have to think about it. Kinda had my mind set on teal.
Powered by vBulletin® Version 4.2.5 Copyright © 2024 vBulletin Solutions Inc. All rights reserved.