Footloose
02-11-2005, 11:44 AM
I am trying to dial in a project boat which has twin 425 HP 502s and a pair of arneson drives. Questions to perormance prop folks are getting me very inconsistent answers. With I/O, Inboards, and even outboards, you know a prop is right when you can pull the engines WOT RPMs with them. If you can't, the props are probably too large (over-proped)
Is this also the case with Arneson surface piecing drives/props since when up on plane these props are supposed to be half in the water and half out?
Is this also the case with Arneson surface piecing drives/props since when up on plane these props are supposed to be half in the water and half out?