View Full Version : Salisbury exhaust flappers... ???
Lenny
02-11-2005, 09:13 AM
Here is a pic of my original exhaust outlets on the transom. I want some flappers for them as I am not going to change them out till next winter when the whole thing comes apart to do a tank and deck stripe/paint etc.
The problem is, I want Salisbury flappers for them and they measure 3 3/16"- 3 1/4" on the outside of the casting. Where do I get some flappers to fit onto these?
Greg K
02-11-2005, 09:23 AM
Use the 3 inch size.. get em at Eddie Marine..
Flappers (http://www.eddiemarine.com/cart/details.asp?SubCategoryID=139&CategoryID=139)
Lenny
02-11-2005, 10:37 AM
Thanx Gregg.
Done, ordered, shipped :D
...and the 3" are Salisbury.
Lenny
02-18-2005, 07:50 PM
Thanks Greg. They fit perfect even tho the outlets are about 3 3/8". A bit of lube and they went right on :eek:
One more thing done. :)
Just like all rubber thingies! :garfield:
Greg K
02-18-2005, 09:47 PM
Help when and where I can... :bonk:
RedDog
02-18-2005, 10:31 PM
Thanks Greg. They fit perfect even tho the outlets are about 3 3/8". A bit of lube and they went right on :eek:
One more thing done. :)
one more thing - put the screw on the bottom and you won't see it unless you are in the water swimming by the transom :D
Lenny
02-18-2005, 10:51 PM
Good point, ...
It never ends does it...
I have to go iron my socks
RedDog
02-18-2005, 11:49 PM
Good point, ...
It never ends does it...
I have to go iron my socks
details - my Mom ironed my boxers and its hard to beat a freshly pressed bed sheet...
Ed Donnelly
02-19-2005, 12:00 AM
My wife wants to know what an iron is...........Ed
Powered by vBulletin® Version 4.2.5 Copyright © 2024 vBulletin Solutions Inc. All rights reserved.