View Full Version : !!!HOW!!! flexible is the 4" exhaust hose???
Lenny
10-10-2004, 11:03 PM
Curious as to whether I can leave my "holes" in the transom with new Merc exhaust or a re-glass fill deal is in the works.
I woud like to just bolt on some 4" manifolds and tweak the hose to align with the existing thru-hulls...
I have no idea how flexible it is.
gcarter
10-11-2004, 07:25 AM
Uhhh.....would you believe 'Not at all'? :bawling:
Greg K
10-11-2004, 07:26 AM
Where does your exhaust exit ? below or at waterline?
You may need an S-pipe or a couple of elbows.
I found some slightly flexible 4" hose at a place in Franklin Wi. called Kendor corp. Ph.#414-421-4370. FAX 414-421-7236. Website that I can only get to sometimes www.kendormarine.com
Ranman
10-11-2004, 08:38 AM
Lenny,
I don't have a LOT of experience with the hose, but I would say on an ! 18" run you wouldn't wasnt to be off target more than an inch in any direction.
Lenny do a search on the net for fiber glass exhaust parts, there is some really good problem solvers out there. Or do what I have done many times, get F/G exhaust tubing V notch it to get the offset you need then glass over the V notches.
Phil
Lenny mail these guys this stuff does bend very well may be the end it all.
http://www.tridentmarine.com/stage/wetexhaust.htm
penbroke
10-11-2004, 03:14 PM
Check out mesamarine. (http://www.mesamarine.com) They have great prices and are very helpfull.
Frank
I agree with George's assessment.
RickR
10-11-2004, 08:10 PM
FLEXIBLE??????? :rolleyes: NOT!!!!!!!!!!
Rootsy
10-11-2004, 08:20 PM
Flexible... NO... it'll deflect a "slight" bit but trust me... it is no picnic if your alignment is off even a 1/4 inch... if you bend it too far it'll just kink and collapse on you...
smoothie
10-11-2004, 08:59 PM
Heres a good place for the elbows if they dont have it in stock they can make what ya need.
http://shop.airflowonline.com/Merchant2/merchant.mv?Screen=CTGY&Store_Code=AFSI&Category_Code=EE
http://shop.airflowonline.com/Merchant2/merchant.mv?Screen=CTGY&Store_Code=AFSI&Category_Code=RHC
Ed Donnelly
10-11-2004, 09:28 PM
Lenny; Give me the offset diamentions and I.D. of the exhaust tube, and I will make you the offsets..
PS need the Length between the transom and the riser outlet...Ed
Powered by vBulletin® Version 4.2.5 Copyright © 2024 vBulletin Solutions Inc. All rights reserved.