View Full Version : 502 fresh cooling
marcdups
10-07-2004, 08:36 AM
How can I make a 502 cooling system fit a 350 mag??any one attempted this yet as for room and such in an 18?
BTW, am looking for an intake for a small block with heat choke and vortec head bolt pattern and square bore carb, ie , weber., thanks
Jamesbon
10-07-2004, 10:04 AM
Sounds easy to me. Just plumb it like you normally would, then let the thermostat take care of regulating the temp.
You wanna sell the heat X for a 502? I may be in the market...
marcdups
10-07-2004, 02:19 PM
Nathan I have two of then gimme a call, 843 907 2492, I will check in my stock parts and let you know, but will not be until tomorrow
marcdups
10-07-2004, 03:08 PM
also have the intake for a 502
You don't have a bunch of room up front, you may want to consider mounting the exchanger down on brackets off the stringer. The is a thermostat housing that incorporates a radiator cap it make a pretty simple job. I am pretty sure Big Griz has one of his setup that way.
marcdups
10-07-2004, 09:30 PM
Mop are you talking about the thermostat housings that Crusader uses??
I have seen several the one I liked best were the ones on Chrysler 318's years back, a decent little cast aluminum jobby.
Powered by vBulletin® Version 4.2.5 Copyright © 2024 vBulletin Solutions Inc. All rights reserved.