View Full Version : Gil headers
Someone should jump on this setup!
http://cgi.ebay.com/ebaymotors/ws/eBayISAPI.dll?ViewItem&item=2492157382&rd=1&sspagename=STRK%3AMEWA%3AIT
Lenny
10-06-2004, 11:01 PM
MOP, why are they NOT the same length??? and what is that fitting at the end of the run for? (at transom)
Lenny
10-07-2004, 03:03 AM
Think I'll pass as I don't know about this stuff.
1 min 32 secs
7-day listing
Ends Oct-07-04 00:57:36 PDT
I don't like walking in blind when it come to motors and drives... :(
Lenny sorry was sleeping when you posted, the length looks the same for both. Gil gets $2,800 for the set I have with the long tube aluminum risers, I got a very good deal on mine.
Lenny
10-07-2004, 09:56 PM
Phil ,the header closest to you has less meat after the last weld at the transom.
http://i15.ebayimg.com/02/i/02/8d/39/01_1.JPG
They look different lengths to me.
Yup I see where the owner trimmed off some of the dry part of the tube, I still would have grabbed them. The risers look too long for our applications, the SB manifolds are the important part they do not show up often. S/S risers show up all the time on Ebay fairly cheap many will fit with no worries as the manifolds are dry joint.
Phil
Powered by vBulletin® Version 4.2.5 Copyright © 2024 vBulletin Solutions Inc. All rights reserved.