MOP
07-20-2004, 08:40 PM
Got a few steps ahead with putting the 22 back together, well at least one side of the engine. Factory valve covers back on, ran tap in holes and installed S/S studs for headers. Went to slide on lower halves was a No/Go hit the alternator pulled it back out, was PO-ed looked things over again and found a canted fitting on other manifold. Ok tried that WaLa slid right on, dropped the riser on snugged it up. Then looked through the old exhaust cut out it is in perfect alignment well that is with a tad of massaging with the scroll saw! Now to find some of that nice silicone BLUE hose!