View Full Version : Machine turning or Damascening
harbormaster
06-08-2004, 10:24 AM
Does anyone know where I can get my hands on a peel and stick "machine turned" look covering. For those who have no idea what I am talking about, its like the old trans am dash panel finish.
Lenny
06-08-2004, 10:42 AM
Scot, it was referred to "back then" as engine turned aluminum.
http://www.cs.ucr.edu/~eamonn/et/et.htm
http://www.allfoils.com/services.html
Greg K
06-08-2004, 11:50 AM
Available here in gold and silver. The small pattern is 1/4 inch in diameter and the large is 7/8 inch diameter.
:lightning http://www.beacongraphics.com/signgold.html :lightning
Powered by vBulletin® Version 4.2.5 Copyright © 2024 vBulletin Solutions Inc. All rights reserved.