Crane energizer rockers

[Ralph Savarese]

Will Crane energizer 1.6 Roller rockers fit under srandard valve covers? If not what could you do to make them fit Thicker gasket or spacers?
I know some of you have installed them!
I have new cast aluminum Valve covers I want to keep that are standard height.
Thanks Ralph

[MOP]

Ralph I found a set of spacers but am holding off until I get the covers off the Tempest, I have been told I will not need them, they will fit due to the newer style locks. I have both 1.6 and 1.5's sets but will run the 1.5's in the new motor, maybe change later. I have tried 1.6's in the past did not notice much if any change in performance.

[Ralph Savarese]

Mop i just need info on what to do?

[Rootsy]

They SHOULD fit. but always test fit eh...

aluminum roller rockers and poly locks fit under standard 300 tempest rocker covers (cast aluminum Corvette covers) even WITHOUT gaskets...

stamped steel comp cams rockers and poly locks fit under my SHORT aluminum covers with a standard thickness gasket.

[MOP]

Thanks Jamie, my plan was to turn it over with no gaskets then do what ever was needed.

Phil