GKricheldorf
04-22-2004, 09:49 AM
Turns out the new motor I purchased is a Gen VI. My intake manifold off my Mark IV will fit on the new motor, but I had to remove the splash plate off the bottom of the intake and remove the snap in splash plate. This leaves almost nothing to stop the oil splashing.
I've been searching with out getting any definitive answers on what intake manifold I can use. I don't want to buy something that later needs to be returned.
Any of you guys have a Chevrolet part# for your intake on a Gen VI 454? And or a picture of the bottom? I kind of want to stick to cast iron to keep the expansion from heat even, but will use an aluminum one if need be.
I've been searching with out getting any definitive answers on what intake manifold I can use. I don't want to buy something that later needs to be returned.
Any of you guys have a Chevrolet part# for your intake on a Gen VI 454? And or a picture of the bottom? I kind of want to stick to cast iron to keep the expansion from heat even, but will use an aluminum one if need be.