View Full Version : Need some help with some dimensions
Rootsy
04-13-2004, 11:23 AM
I'm finishing up my steering and i can't seem to find a few dims that i verified when i was home. Could someone please give a look at their alpha with a ruler or pair of calipers and get me 2 dimensions so that i don't go drilling holes in the wrong spot on this wing plate? measure twice.. or three times.. cut once...
THANK YOU!
JR
BUIZILLA
04-13-2004, 11:56 AM
X = 1.945
Y = 5.110
those dimensions are from the HOLE centers on my spare outdrive, not the stud centers, your numbers may vary :banghead:
I think... :propeller
Rootsy
04-13-2004, 12:36 PM
thanks jim.. i had 5.12 and 2.00 inches on my print... also... one last thing.. how bout the diameter of the stud hole? i have clearanced hole for a 7/16 stud...
Thanks
JR
BUIZILLA
04-13-2004, 01:08 PM
My holes are .520
I measured the other spec's as close as I could, but I don't think I am off as much as .055 on that one dimension...
J :wink:
Rootsy
04-13-2004, 01:57 PM
THanks again jim... i owe you a beer whenever our paths cross...
Powered by vBulletin® Version 4.2.5 Copyright © 2024 vBulletin Solutions Inc. All rights reserved.