View Full Version : Transom Eye rings
JimG205
03-02-2004, 02:48 PM
Anyone know the size and a source for the transom eye rings that bolt through on the rear corners of the transom-want to put a pair on my 86 Minx-
" Hey Phil-this should be right up your alley!!! "
Thanks in advance-Jim :jestera:
mphatc
03-02-2004, 08:31 PM
Known as Stainless Steel Bow Eyes, and or Transom Eyes
,
Made by EPCO
Available from Lewis Marine and other suppliers
MPHATC
gcarter
03-03-2004, 06:47 PM
http://cgi.ebay.com/ebaymotors/ws/eBayISAPI.dll?ViewItem&category=26446&item=2464232294
Is this what you were looking for?
George
JimG205
03-04-2004, 09:16 AM
http://cgi.ebay.com/ebaymotors/ws/eBayISAPI.dll?ViewItem&category=26446&item=2464232294
Is this what you were looking for?
George
Yes George,those are the ones-believe they are 3/8" dia.Thanks,Jim--How's your Minx coming along??
gcarter
03-04-2004, 09:55 AM
Yes George,those are the ones-believe they are 3/8" dia.Thanks,Jim--How's your Minx coming along??
Thanks for asking.
I'm working on several things at once;
1) A new engine is being built.
2) New upholstery is being made.
3) A new wiring harness was purchased on eBay.
4) I'm cosmetically restoring the drive. I'll post photos soon.
5) Removed and am replacing the transverse frame or "offshore mount".
6) Building angle support for cockpit rear seat area. Photos soon.
7) Smoothing and refinishing engine compartment.
8) Am ordering Victory tabs and many SST engine brackets.
9) New gauges soon & maybe new dash.
I hope to be finished in about two months.
Not too bad considering I picked it up on 1-5-04!
George
And much thanks to everyone on this site who have been so helpful!!
Powered by vBulletin® Version 4.2.5 Copyright © 2024 vBulletin Solutions Inc. All rights reserved.