PDA

View Full Version : Bravo Trim-In Limit Pin



RedDog
02-26-2004, 09:39 AM
While reinstalling my Bravo I drive, I found that my trim-in limit pin was installed in the location specified for a Bravo III (according the the manual I have - see attached). 1) Why are there different installation locations for the different drives 2) Why would mine have been installed incorrectly - simple error or some other secret reason known only to Bravo gurus.

When installed in the Bravo I location, I can see that the drive can trim in farther but less in the outward direction.

MOP
02-26-2004, 10:26 AM
RD it looks like in the proper position you can trim in just a bit more which will help planing off a tiny bit better, the drive will not go up quite as much but that is irelivant you don't want to trim out that far anyway.

Phil