View Full Version : Guess What This Is?
Here's a new part for Mighty Mouse. :stan:
Never saw one but it looks like a regulator or pop valve?
MOP,
Where did you find that woman? http://www.donzi.net/forums/image.php?u=565&dateline=1075388003
Gee thought you were going to laugh at my answer! Where I got her I can't remember thats not unusual for me! That one is tame won't use some of the other wiggly ones!
Now tell me is that a water pressure regulator??
Phil / MOP
Merc. Racing relief valve for the raw water cooling.
Have you considered one of these little Jubies? The 70P, no more rubber impeller, rehab is a snap needed at 300 hours or more, take less HP. I have worked with these pumps for years on commercial boat great flow for little effort. Hell you got a rotor sucking air, why not water? They are worth checking out for anyone running an engine driven raw water pump. On the site, flow rates at what rpm's, HP needed. They must be mounted below water line as they are not self priming, the head can be rotated in the mount helps point the out where you want it. Look under bronze centrifugal They are an interesting alternative to rubber impeller pumps.
http://www.oberdorfer-pumps.com/pumps/products.htm
DON N.
02-14-2004, 07:19 PM
Geoo, If P.r. Valve Does Pop Is It Connected To A Bilge Line ?
I Work Around Large Tanks With P.r. Valves And They Don't Always Reset.
The 1" release nipple goes to a thru-hull discharge.
I think my buddy just put one in his boat. He was convinced his water pressure caused an intake manifold gasket failure.
Powered by vBulletin® Version 4.2.5 Copyright © 2024 vBulletin Solutions Inc. All rights reserved.