Formula dash upgrade

[Cuda]

I'm ready to install the redone dash on my 20 SC.

Before and after.
http://www.donzi.net/photos/jgriffd1.jpg


http://www.donzi.net/photos/jgriffd2.jpg

[catch 22]

After, I definitely like after. Very nice job.

[Team Hula Girl]

Cuda, are you going to put a formula Sticker/badge above the tach/speedo like the old one? It looks like it might spruce up the all yellow guage plate. Looking forward to seeing it when it gets done.

John

[MOP]

SWEEEEET!

[Cuda]

I also removed the padded dash and made a piece of plexiglass for it. The wood grain contact paper is gone. :rolleyes: I can't get the destroyer wheel off, I have a a Spargi wheel to replace it with. When I try to remove the wheel, the nut will only back off so far, then starts spinning. It will tighten back up, but can't get it off.
http://www.donzi.net/photos/jgriffwheel.jpg

[MOP]

Cuda with the nut in the tightened position center punch one of the shollow flanks, drill it straight toward the wheel with as big a drill bit as you can without getting into the thread area. You will have to drill it through into the exsisting wheel hub. Use a small sharp chisel and split the nut to get it off. Hopefully the new wheels hub is not thicker so you will still have the good thread area to work with. If not I would dump the helm.

[Cuda]

MOP, that's what I was thinking, I could cut the nut nearly in half with my 4 inch angle grinder, then split it with a cold chisel.

[Ed Donnelly]

Or,rent a nut splitter 60 second job that way..Ed