PDA

View Full Version : Stainless risers



MOP
06-09-2003, 08:30 PM
I have a few S/S Merc risers, the last set went fast. These are factory standard style center risers for any Merc application. They are less than 1/2 the weight of cast iron and the exhaust outlet is 2-3/4 opposed to 2-1/2 for the cast iron version. You can chop off about 20lbs in weight and may see a very slight improvement in preformance. The Big Plus is you will never need to buy risers again. These are used $100 takes a pair less than half the price of cast iron risers. They polish up fantasticly. Bolt patern is 3-1/4 by 3-3/8 on center. They do not use the long 4+ inch studs to mount they bolt or short stud to manifolds.

If you have questions E-Mail me.