View Full Version : another stainless manifold question
Digger
11-29-2002, 02:48 PM
are the stainless marine manifolds any wider than stock mercruiser? my engines are so close together...if they are any wider I think I will have "issues". thx in advance for any input.
Bryan Tuvell 33ZX
11-29-2002, 03:30 PM
DIGGER, I will take some measurements on mine tomorrow for ya.
Bryan
HP 600SC
11-29-2002, 03:32 PM
Digger, I installed them on my 33' and my stock manifolds were so close that I could not get a finger in between. The Stainless marine manifolds actually had a bit more room in between when finished.....but what a fun job :rolleyes:
Ted M.
Bryan Tuvell 33ZX
11-30-2002, 12:33 PM
DIGGER, pic's in a bit, stay tuned, looking for a wood ruler. :) Bryan
Bryan Tuvell 33ZX
11-30-2002, 03:08 PM
Forgive the shakey hand...
Jessica just had her 1st F250 PSD driving lesson, first lesson ever....
No wooden ruler but I made sure the tab was in the right spot for the photos.
Digger I replied to your email.
Bryan
http://www.donzi.net/photos/tuvellsm001.jpg
http://www.donzi.net/photos/tuvellsm002.jpg
http://www.donzi.net/photos/tuvellsm003.jpg
Digger
11-30-2002, 06:24 PM
Bryan/Ted, thanks! My motors are now out of the boat, sitting in my mech's shop. (they sure look a heck of a lot bigger out of the boat :) ) will make install easier.
Bryan Tuvell 33ZX
11-30-2002, 06:32 PM
Good luck Digger, keep us posted and scrub that bildge! Maybe paint it Orange or something!
Kidding of course....
Pictures?
Bryan
Crossbow
12-01-2002, 09:46 AM
Hey Brian ,as long as your answering stainless marine questions,mine is ,How much farther back does the stainless set you got exit compared to your stock(i assume )manifolds ? I was thinking about going with them and was hoping to still be able to use my stainless Z pipes on my crossbow ,What do you think??
Bryan Tuvell 33ZX
12-01-2002, 10:15 AM
CROSSBOW, mine won't ne in the boat for a couple more weeks, I plan to document the entire install for the websites, that will show ease/problems and hopefully get a free hat from the HMaster!
Once in I can take any measurement you would like.
Bryan
Crossbow
12-01-2002, 11:56 AM
Thanks Brian ,that would be great ,besides I'm not going to do my manifolds until early spring ,just considering my options at this point . Look foward to you installation pics !! wink
Powered by vBulletin® Version 4.2.5 Copyright © 2024 vBulletin Solutions Inc. All rights reserved.