View Full Version : Merc to OMC ?
Just out of courisity is there any way to retrofit a typical non solid hub Merc prop to fit a OMC King Cobra. Also, will any of the solid hub Merc props fit the Cobra shaft.
THX
Sam
Greg K
11-17-2002, 06:39 PM
The only Mercs I know of are the the Merc props with the Flo-Torq II hub system. There is a hub system for the OMC to fit Merc props on them. Unless the prop can be re-hubbed to fit the different number of splines.
Are you in the market for a new prop? If so check the URL below they have a great selection of props for every application..
http://hlsm.com/
M.O.P., thanks for the link but I am trying to clear a few props out. Someone asked if any of my Merc props would fit an OMC.
THX
Sam
Powered by vBulletin® Version 4.2.5 Copyright © 2024 vBulletin Solutions Inc. All rights reserved.