banfield
08-26-2003, 08:16 PM
Hi,
I've had my 22 classic for about 1 month, and started noticing a bit of white spots developing on the drive. Unfortunately, I am storing it in the water this summer until I get a lift built for next year. The white spots made me question the mercathode's function.... I finally looked at it, and found it isn't connected!
Would someone post or email me a factory manual page showing where I should be connecting the R and A wires from the mercathode?
If it matters, I have a 89 454 carbureted and a 89 bravo I drive. The drive has some old anti-fouling paint on it (but the gimble housing doesn't). Will the paint screw things up (I'm a fresh water kind of person, so I'm not used to the paint).
Also, the mercathode is located just above the fuel pump on my engine. Is this the normal location?
Thanks alot!
Don Banfield
I've had my 22 classic for about 1 month, and started noticing a bit of white spots developing on the drive. Unfortunately, I am storing it in the water this summer until I get a lift built for next year. The white spots made me question the mercathode's function.... I finally looked at it, and found it isn't connected!
Would someone post or email me a factory manual page showing where I should be connecting the R and A wires from the mercathode?
If it matters, I have a 89 454 carbureted and a 89 bravo I drive. The drive has some old anti-fouling paint on it (but the gimble housing doesn't). Will the paint screw things up (I'm a fresh water kind of person, so I'm not used to the paint).
Also, the mercathode is located just above the fuel pump on my engine. Is this the normal location?
Thanks alot!
Don Banfield