CDMA
10-22-2001, 11:29 AM
First of all here are the Aluminum boxed stringers....
http://www.donzi.net/photos/callard32.jpg
Now I would like to retain these but I need somewhere to mount 2 batteries and 3 trim pumps as far aft as possible. I would build accessory shevles in the back like my 18 but the boxed aluminum section carries all the way to the transom and is nicely bolted to it as a brace. I was looking at the side dimond plate "walkways" on the sides of the engine in the 22 special eddition. How do these mount and could I do it without fiberglassing to the stringer?
If not any other ideas would be helpful..
Chris
http://www.donzi.net/photos/callard32.jpg
Now I would like to retain these but I need somewhere to mount 2 batteries and 3 trim pumps as far aft as possible. I would build accessory shevles in the back like my 18 but the boxed aluminum section carries all the way to the transom and is nicely bolted to it as a brace. I was looking at the side dimond plate "walkways" on the sides of the engine in the 22 special eddition. How do these mount and could I do it without fiberglassing to the stringer?
If not any other ideas would be helpful..
Chris