AGUESS
09-09-2001, 03:17 PM
I need to cut new holes for my lifting rings. Old holes were filled in during restoration of my Classic 18.
I only have the lifting rings, no trim rings, might need to buy some from Rich.
Questions.
1. What size hole saw to use? I don't know the width of the trim rings.
2. How much of the lifting ring (height) should show above the deck? This will help me with the mounting of the transom bracket.
Thanks again for all of your help.
Alex. :confused:
I only have the lifting rings, no trim rings, might need to buy some from Rich.
Questions.
1. What size hole saw to use? I don't know the width of the trim rings.
2. How much of the lifting ring (height) should show above the deck? This will help me with the mounting of the transom bracket.
Thanks again for all of your help.
Alex. :confused: