PDA

View Full Version : alignment



Zinger
02-11-2003, 04:07 PM
HI everyone , i purchased a mercruiser alignment tool 91-805475A 1 and in the owners manual it spoke about the ease this shaft should slide ,with the engine rotated each 90 degrees the tool slides in and out of the coupler fairly easy but not with two fingers like the manaul said.The alignment tool is new and it has some lines in the shaft has anyone had this problem with the engine alignment. Thanks Jeff

MOP
02-11-2003, 04:23 PM
What we have always done is to apply a thin coat of grease on the tool. This lets you see where it may be binding. After awhile you get real good at reading the grease! When its pulled up you should see the slines with an even coating of grease all the way around.